Installation manual

Part No. T0001-43, Rev B
February, 2003
New Features Page 11 of 99
Warning
Your Vanguard product was designed and certified for use with specific memory
option SIMMs. It is IMPORTANT that you install only the devices that are certified
for use with your Vanguard product. Installation of an incorrect FLASH SIMM
module could result in damage to the SIMM device or your Vanguard Product.
Please see the list below for the memory device that is compatible with your
hardware platform.
Vanguard 6400 Compatible FLASH SIMM Devices are as follows:
4-Meg FLASH Devices
PN - "EDI7F292MC100BNC"
PN - "SM70848XA2JIES2"
8-Meg FLASH Devices
PN - "IW388X1-R-120"
PN - "EDI7F492MC120BNC"
The FLASH SIMM Device Part Number (PN) can be found in small print on the face
of the SIMM device. For further assistance, please call VanguardMS Service. For
more information on the Vanguard 6435 and 6455 Series increases, refer to the
Installing Flash and CMEM section of the 6435/6455 Installation Manual
(Part Number T0166).
Vanguard Dynamic Host Configuration Protocol (DHCP)
Dynamic Host Configuration Protocol (DHCP) is a communications protocol that
allows administrators to automate the assignment of Internet Protocol (IP) addresses
in a network. Every unit connected to the Internet needs a unique IP address. This
feature enables the Vanguard to act as a DHCP client and request configuration
information for a DHCP server. For more information, refer to the Vanguard IP
Routing Manual (Part Number T0100-03).
Vanguard Ethernet QoS 802.1 P & Q VLAN Support
A Virtual LAN (VLAN) is a switched network that is logically segmented on an
organizational basis rather than on a physical or geographical basis. Workstations or
servers used by a particular work group team, can be connected to the same VLAN,
regardless of their physical connection to the network. For more information, refer to
the Vanguard IP Routing Manual (Part Number T0100-03).
Vanguard Interoperability with RADIUS Authentication
The purpose of Remote Authentication Dial-In User Server (RADIUS) is to enable
Vanguard routers to interoperate and support RADIUS attributes. Vanguard routers
are able to act as a RADIUS client. For more information, refer to the Vanguard IP
Routing Manual (Part Number T0100-03).
Vanguard 6455 T1/E1 DC/FC Performance Improvement
Increased T1/E1 feature card performance for the Vanguard 6455 is available with
Release 6.2 and greater software. For more information, refer to the Vanguard 6435/
6455 Installation Manual (Part Number T0166).