Installation manual

4-2 Powering Up Your Vanguard 3400 Series

Power Up Procedure

Introduction This section explains how to power up the Vanguard 3400 Series.

Procedure Follow these steps to power up your Vanguard 3400 Series.

To power down the Vanguard 3400 Series, unplug the power supply AC power cord

from the power receptacle

LEDs Figure 4-1 shows the Vanguard 3400 Series LEDs and the table that follows

describes them.

Figure 4-1. Vanguard 3400 Series LEDs

Step Action

1 Ensure that all the cards are fully inserted and secure.

2 Ensure that the AC power cord is plugged in.

3 Ensure the front panel power LED is on.

Power Stats

LED Description

3400 Series System State

Initial

PowerON

Diagnostics

Executing

SW Loa

ding Operational

Status

Power Power OK On On On On

Stats Diagnostics/SW

On Off Blinking On