Installation manual

Hardware Description 2-13

Vanguard Networks Daughtercards

• For V.35 or V.36, use 51177 DCE-DTE cable adapter and 1152-10021

V.35/V36 cable adapter

Figure 2-15. 2-Port Serial Daughtercard Connector

DIM Daughtercard This card supports a single V.11/X.21, V.24/RS232, V.35, or V.36 DIM (Digital

Interface Module) and can be

set as either a DTE or DCE.

Figure 2-16 shows the DIM Daughtercard connector as it appears on the back panel.

Figure 2-16. DIM Daughtercard Connector

ISDN BRI-U

Daugh

tercard

This card provides 2B+D Channel through an ISDN BRI U interface. It co

nforms to

ANSI T1.601 1992 (2B1Q), is LAPD:ITU Q.921 compliant, and supports the

following:

•Integral X.31

• Q.931 dial support

• NI1, 5ESS, DMS-100 switch types

• D Channel Packet Mode

• Leased Circuit Services (I Interface)

• Japan High-Speed Digital

Figure 2-17 shows the ISDN BRI-U Daughtercard connector as it appears on the

back panel.

Figure 2-17. ISDN BRI-U Daughtercard Connector

ISDN BRI Voice

Daughtercard

This card provides 2B+D Channel through a BRI S/T in

terface. It conforms to ITU

I.430, is LAPD:ITU Q.921 compliant, and supports:

•Integral X.31

• ITU-T Q.931 (EURO IDSN) - ETSI switch type to connect to PBXs and

ublic networks.

• ECMA 143 - QSIG Basic Service to connect to PBXs over private line.

• ECMA 165 - QSIG Generic Functions for Support of PBX Supplementary

2P-SDC

DIM SITE

BRI U