Gateway Series Installation Manual
Table Of Contents
- Cover
- Notice
- Contents
- About This Manual
- Translations
- Customer Information
- Chapter 1, About the Vanguard 3400 Series
- Chapter 2, Hardware Description
- Overview
- Enclosure
- Motherboard
- Vanguard Networks Daughtercards
- Supported Daughtercards
- Daughtercard Compatibility
- Figure 2-6. New Vanguard 3400 Series Daughtercard Example
- Figure 2-7. 56K DSU/CSU Daughtercard Connector
- Figure 2-8. FT1 and FE1 Daughtercard Connectors
- Figure 2-9. Dual E&M Daughtercard Connectors
- Figure 2-10. FXS Daughtercard
- Figure 2-11. FXO Daughtercard
- Figure 2-12. V.90 Modem Daughtercard Connectors
- Chapter 3, Installation and Replacement
- Overview
- Checking Your Shipment Contents
- Installing The Vanguard 3400 Series
- Modifying Your Vanguard 3400 Series
- Chapter 4, Powering Up Your Vanguard 3400 Series
- Appendix A, Specifications
- Appendix B, Software License and Regulatory Information
- Return Procedures
- Index
Installation and Replacement 3-3
Installing The Vanguard 3400 Series
Installing The Vanguard 3400 Series
Introduction This section explains how to install the Vanguard 3400 Series. It consists of these
sections:
• Selecting and preparing the installation site.
• Installation.
• Thermal considerations.
• Cabling.
After the Vanguard 3400 Series is installed and cabled, go to Chapter 4, Powering
Up Your Vanguard 3400 Series for instructions for powering-up the unit.