Owner's Manual
MOUNTING
VAIL
CAST
INTO
THE
WALL
WIRE
MANAGEMENT
As the
number
and
variety
of
wires exiting the
wall
may
vary,
we
recommend a Pass-Through
Wall
Plate
at
the location the wires exit the
wall.
KNOCK-OUT
You
may
have the VAIL Cast
located
behind a TV
and
wish
to
connect the
Optical
Cable
and
the
IR
receiver
directly
from the mounting location. There
is
a
"knock-out"
located
at
the bottom in the middle
that
can be removed with a small
pair
of
pliers.
Once
removed cables, assuming they
are
narrow
enough
to
do
so, can be pulled through the
opening
from the
back
of
the unit
to
the front
and
out
at
that
location.
OTHER
CONSIDERATIONS
Wires
from the VAIL Cast
may
be
run
to
a remote location
or
simply
dropped
down
the
wall
cavity
in
the stud
bay
that the VAIL Cast
is
mounted into. Please place the
power
supply
exterior
to
the
wall
cavity
and
only
run the
low
voltage
wire
through the
wall
cavity.
Depending
on location you
may
need
to
lengthen the cable.
While
the
power
attached
to
the VAIL Cast
is
low
voltage, local regulations
and
codes vary. Please check
locally
if
you have
any
concerns.
USING
THE
VAIL
CAST
AS
A
SOURCE
(AUDIO
OUT)
While
the VAIL Cast has an excellent built-in amplifier, you
may
wish
to
use it as a source that can be
connected
to
a
larger
amplifier
or
multi-zone amplifier.
To
do
this connect the
Out
jack
to
an external
amplifier.
Anything
that
is
heard
from the built-in
amplifier
will
be
delivered
at
line level
to
an external
amplifier. If you wish you can still
operate
the built-in
amplifier
and
simply
expand
it
to
additional
areas using the
Out
jack.
Phone :
{866)
834-6321
Email: info@vanguarddynamics.com
1299
Columbia Ave
E6,
Riverside,
CA
92507
www.vanguarddynamics.com