Owner's Manual
TV
CONNECTION
IMPORTANT:
One
advantage
of
the VAi L Cast
is
that it allows
you
to listen to
audio
from
your
TV through the speakers connected to the VAIL Cast.
Most
new
TVs
have a
"fixed"
audio
output.
That means that while the remote
for
the TV will control the volume on the TV it will not raise,
lower
or
mute the
audio
output (optical
or
digital) from
your
TV.
To
control the volume on
your
TV you will need to learn the
IR
commands from
your
TV remote into the VAIL Cast
as
described.
Step
1.
Connect
your
TV
audio
to the VAIL Cast. If it
is
an optical output on the
TV,
use
an optical
audio
cable
and
connect to the OPTIC input on the VAIL Cast. If it
is
an
analog
audio
output connect
the
audio
output to the jack marked LINE on the VAIL Cast.
The
LINE jack
is
a 3.5mm stereo input.
Step
2.
To
control volume via an Infrared TV remote, connect the included
IR
receiver to the plug on
the
back
of
VAIL Cast. If you plan to
use
an
IR
receiver not supplied, it MUST
BE
3 volts. Once the
IR
receiver
is
connected
follow
the steps
below
using the remote
of
the TV
/source
you have the VAIL
Cast connected to.
1.
Press
and
hold
down
VOLUME
UP
and MUTE buttons simultaneously on VAIL Cast
for
5
seconds to enter
IR
learning mode until
OPT
led blinks purple.
2. Once CAST led blinks white, point the remote control to the VAIL
IR
receiver
and
press
VOLUME
DOWN
on
your
remote control 3 times, then press VOLUME
DOWN
on VAIL Cast 3
times. OPT led will blink purple
as
confirmation that VOLUME
DOWN
has been programmed.
3. Once OPT led blinks white, point remote to the VAIL
IR
receiver
and
press MUTE on
your
remote control 3 times, then press MUTE on VAIL Cast 3 times. OPT led will blink purple
as
con-
firmation that MUTE has been programmed.
4. Once AUX led blinks white, point remote to the VAIL
IR
receiver and press VOLUME
UP
on
your
remote control 3 times, then press VOLUME
UP
on VAIL Cast 3 times. OPT led will blink
purple
as
confirmation that VOLUME
UP
has been programmed.
After
Completing the above steps, please test to make sure the commands are
working
with the
source operating.
Phone :
{866)
834-6321
Email: info@vanguarddynamics.com
1299
Columbia Ave
E6,
Riverside,
CA
92507
www.vanguarddynamics.com