Owner's Manual

Important
Safety
Instructions
1.
Read these instructions -
All
the safety
and
operating instructions should
be
read
before this product
is
operated.
2. Keep these
instructions - The safety
and
operating instructions shou(d
be
retained for future reference.
3.
Heed all warnings -
All
warnings on the appliance
and
in
the operating instructions should
be
adhered
to.
4.
Follow all instructions -
All
operating
and
use instructions should
be
followed.
5.
Do
not use this
apparatus
near
water
- The appliance should not
be
used
near
water
or
moisture - for example,
in
a wet basement
or
near
a swimming pool,
and
the
like.
6.
Clean only with a
dry
cloth.
7.
Do
not block
any
ventilation openings. Install
in
accordance
with the manufacturer's instructions.
8.
Do
not install
near
any
heat
sources such
as
radiators,
heat
registers, stoves,
or
other
apparatus
(including amplifiers} that produce
heat.
9.
Do
not
defeat
the safety
P,UrP,ose
of the polarized plug,
if
provided. A polarized plug
has
two
blades
with
one
wider than the
o_ther.
The wide
blade
or
the thira prong
is
provided for your satety.
If
the provided plug
does
not
fit
into your outlet, consult
an
electri-
cian for replacement of the obsolete outlet.
10. Pr(!tect_the
power
cord from being walked on
or
pinched particularly
at
the plugs, convenience receptacles,
and
at
the point
where
1t
exits from the apP,aratus.
11.
Onlx use attachments/accessories specified by the manufacturer.
12. Unplug the
apparatus
during lighting storms
or
when unused for long periods of time.
13. Refer all servicing to ~ualifiea service personnel. Servicing
is
requirea when the
apparatus
has
been
damaged
in
any
way, such
as; the Rower-~upply c9rd
or
Rlug
is
damaged,
liquid
has
been
spilt
or
objects have fallen into the
apparatus,
the
apparatus
has
been
exposea
to ram
or
moisture,
aoes
not
OP,erate normally,
or
has
been
dropped.
la.
CAUTION: Servicing instructions
are
for use by qualified service P.ersonnel only.
To
reduce the
risk
of electric shock,
do
not
perform
any
servicing other than that contained
in
the operating instructions unless you
are
qualified to
do
so.
FCC
STATEMENT
This
device complies with
FCC
radiation exposure
limits
set forth for
an
uncontrolled environment.
This
device complies with Part 15
of the
FCC
Rules.
Operation
is
subject to the following two conditions: (
1}
this device
may
not cause harmful interference,
and
(2)
this device must
accept
any
interference received, including interference that
may
cause undesired operation.
This
equiement
has
been
tested
and
found to comply with the
limits
for a Class B digital device, Rursuant to Part 15 of the
FCC
rules.
These
limits
are
designed to provide reasonable protection against harmful interference
in
a residential installation.
This
equipment
generates, uses and-can radiate radiofrequency
energy
and,
if
not installed
and
used
in
accordance
with the instructions, may
cause harmful interference to radio communications. Rowever, there
is
no
guarantee
that interference
will
not occur
in
a particular
installation.
If
this equipment
does
cause
harmful interference to radio
or
television reception, which can
be
determined oy turning
the eql!ipment off
and
on, the
l!S~r
is
encouraged
to try to correct the interference by
one
or
more of the following measures:
Reorient
or
relocate the receiving
antenna
Increase the separation between the equipment
and
receiver
Connect the equipment into
an
outlet on a circuit different from that to which the receiver
is
connected
Consult the
dealer
or
an
experienced radio/TV technician for heir. Only
operate
the device
in
accordance
with the instructions
supplied.
This
device complies with
FCC
radiation exposure
limits
se forth
tor
an
uncontrolled environment.
In
order
to avoid the
P,Ossibility
of exceeding tne
FCC
radio frequencx exposure
limits
human proximity to the antenna shall not
be
less
than 2.0cm (8 inches} auring no,rmal op~ration.
Changes
or
m_odifications not expressly
approved
by the party responsible for
compliance could
v01d
the user s authority to
operate
the equipment.
IC
STATEMENT
This
device complies with Industry
Canada
license-exempt
RSS
standard(s}. Operation
is
subject to the following two conditions:
(1}
this advice
may
not cause interference,
and
(2) this device must
accept
any
interference including interference
lhat
may
cause
undesired operation of the device. The device meets the exemption from the routine eva1uation
limits
in
section
2.5
of
RSS
102
and
compliance with RSS-102
RF
e,g,osure. Users can obtain
Canadian
information on
RF
exposure
and
comP,liance.
This
eguipment comP,lies with
IC
radiation exposure
limits
set forth for
an
uncontrolled environment.
This
Class B digital
apparatus
comel1es with
Canaaian
ICES-003.
This
Category
II
radiocommunication device complies with industry
Canada
Standard
RDD-310.
TRADEMARK
AND
LICENSE
r-7
Chromecast
~...J built-in
( G Spotify I @)
Use of the Works with Apple
badge
means that
an
accessory has
been
designed to work specifically with the technology identified
in
the
badge
and
has
been
certifiea by the developer to meet Apple performance standards.
AP,P,le,
iPad, iPad AirbiPaa Pro, iPhone
and
AirPlay
are
trademarks of Apple lnc., registered
in
the
U.S.
and
other countries.
To
control tliis AirPlay
2-
ena
led speaker,
iOS 11.4
or
later
is
required.
Google, Android,
Google
Home
and
Chromecast
built-in
are
trademarks of
Google
LLC.
Amazon,Alexa
and
all related logos
and
motion marks
are
trademarks of Amazon
Inc.
or
its
affiliates.
Use your
phone,
tablet
or
computer
as
a remote control for Spotify.
Go
to spotify.com/connect to learn how.
The Spotity Software
is
subject to third party licenses found here: littps://www.spotify.com/connect/third-party-licenses.
The
device
must
be able to
be
awakened by the Google service
in
various power modes, the
LS9X
module
and
the Ethernet module
in
the device
needs to
be
in
working mode all the time, so the device power consumption
will
be
greater
than
2W
when the device enters the network standby.