Owner's Manual
OFF – OFF switch for the VAIL Amp is located on the front when installed onto a surface and
hidden away once Echo Dot is mounted.
4-OHM – Connect any pair of 4 Ohm in-ceiling, in-wall, or bookshelf speakers OR any two pairs
of 8 Ohm in-ceiling, in-wall, or bookshelf speakers. Power LED will turn ON.
8-OHM – Connect any pair of 8 Ohm in-ceiling, in-wall, or bookshelf speakers. Power LED will
turn ON.
Note: Overloading the amplier with the incorrect impedance or too many speakers may cause
damage to the VAIL Amp.
OFF/4-OHM/8-OHM SWITCH
WALL PLATE
The VAIL Amp wall plate was designed to match seamlessly to your electrical outlets. Recommended
placement of the Wall Plate is next to an electrical outlet for easy access for the power plug. The wall
plate has an analog audio input, subwoofer/pre output, and power plug. The analog audio input
provides a second audio source to the VAIL Amp for your custom speakers. The subwoofer output
provides a convenient location to connect any powered subwoofer to add more bass.
Note: Second audio source must have a variable audio output. The VAIL Amp was not intended for
audio sources with xed audio outputs.
WIRING
The VAIL Amp was designed with exibility in mind. The VAIL Amp uses a CAT-5 cable and a 16-2
AWG power cable to connect the VAIL Amp to the Wall Plate. Extend these common wire standards
to mount the VAIL Amp and Wall Plate in opposite sides of the room if desired, up to 300ft, or a
remote location like an equipment rack.
LIMITED FIVE-YEAR WARRANTY
LIMITED
5 YEAR
WARRANTY
Engineered in the USA | 1 (866) 834 6321 | www.VanguardDynamics.com
4.89mm
0.2 inches
75.10mm
2.95 inches
124.91mm
4.92 inches
4.92 inches
124.91mm
152.16mm
6 inches
6 inches