Hardware Kit: Part 3-Mounting the flat panel screen UP Hook the top of brackets (2,3) onto the top flange of wall plate(1). Then swing the screen down. Tighten the safety bolt (4) on each bracket to lock the screen into place. UP 2 3 1 NOTE: Always use an assistant or mechanical lifting equipment to safely lift and position heavy equipment.
Part 1a-Wood Stud Mounting Part 2b-Attaching brackets to screen with recessed back Center brackets vertically on back of screen. Select the medium(E) or large(F) screws. Attach brackets to screen using four selected screws,four square washers(G) and four spacers(K) at the top and bottom of each bracket. Tighten screws firmly. Do not overtighten. Square washer(G) Use wall plate(1) as a template, make sure it is level, and mark four mounting holes along the center lines of the wood studs.
Part 1b-Concrete Wall Mounting Part 2a-Attaching Brackets To Screen With Flat Back Level wall plate(1) and use wall as a template to mark six holes. Drill six 3/8 ” (10mm) dia. holes 2 ” (50mm) deep. Insert six anchors(I) into holes and secure wall plate with six long bolts(H) and six washers(J).Tighten screws firmly. Do not overtighten . Center brackets vertically on back of screen. Select the small(A or B),medium (C) or large(D).
