Hardware Kit: Part 4-Adjusting display and using cord management the plastic latch Route cords along articulating arm using cord management clip . Articulating arm can be adjusted to position display into desired location. Use allen wrench (I) 5x5 to tighten and loosen the tension screw. Do not overtighten and do not loosen to the point the screws come out.
Part 1a-Wood Stud Mounting Part 3 Attaching Adapter Plate to Wall Plate Attach adapter plate to wall plate by sliding flanges of adapter plate into flanges of wall plate. Secure with Hexagon screw and Plastic latch . Use wall plate as a template, make sure it is level, and mark two mounting holes along the center line of the wood stud. Drill two 3/16” ( 4. 5mm) dia . holes 2 ” (50mm)deep. Level wall plate and attach to wall with two long bolts(H ) and two washers(F ) . Tighten screws firmly .
Part 1b-Concrete Wall Mounting Part 2-Attaching Adapter Bracket to Screen Level wall plate and use wall as a template to mark two holes. Drill two 7/16 ” (10.5mm) dia. holes 2 ” (50mm) deep. Insert two anchors(G) into holes and secure wall plate with two long bolts(H) and two washers(F).Tighten screws firmly. Do not overtighten . Determine the proper VESA mounting configuration for your screen using detail 1. If attaching to screen with Curved back select the small(B) or medium(D) screws.
