User Manual
www.vanco1.com
800-626-6445
5
CONNECT AND OPERATE
1. Place the IR receiver(s) in your desired location(s).
2. Place the IR emitter(s) on the device(s) you want to control. The emitter should be placed directly on the
IR sensor of the device you are trying to control.
3. Plug the IR receiver in the IR receiver jack on the wireless receiver and plug the IR emitters into the
emitter jacks of the connecting block.
4. Connect the power supply to each end.
NOTE: This is a 5v device which can be powered using the USB port of other devices if the specications allow
it. Check the specications of the product you are trying to use for power before you go on site.