Specifications

Table Of Contents

HDMI0404/0808MHDBT

First time setup

Your system is designed so that you can set it up quickly and start using it right away.

Please note that the product warranty does not cover damage due to electrical disturbances. If

possible safeguard your equipment by connecting all provided power supplies to an electrical surge

suppressor / line conditioner.

Before you connect up your system, please ensure that you complete the following:

• Ensure that any manufacturer HDMI link, HDMI control or CEC protocol settings such as

Samsung Anynet Link, Sony Bravia Link, Panasonic Viera Link etc are switched to “off” on

both the source devices and HDTVs that are to be connected to system. This setting is likely

to be found in the HDMI menu settings of the devices you are using.

• After you have changed the CEC setting, switch off all your HDMI source devices and HDTVs

and unplug them from the mains.

• Please ensure that you only connect and disconnect HDMI cables while the central hub /

receivers are powered off.

Connecting up your system

• With them powered off, connect your HDMI source devices to the desired HDMI input ports on

the central hub; 1, 2, 3 or 4.

• For Blu-ray 3D, ‘High Speed’ HDMI cables must be used (usually under 8m in length). Passive

(not Active) HDMI cables over 15m in length are not recommended under any circumstances.

• Connect your most commonly watched source device to HDMI input 1. It is recommended that

if a Satellite HD Receiver is being used that this is connected to HDMI input 1.

• Now connect the Cat cabling from the corresponding TV Receiver locations to the HDBaseT

(RJ45) TV output ports (1, 2, 3 or 4.)