HDBASET™ EXTENDER (330 ft./ 100m) over single Cat5e/Cat6 Cable Vanco Part Number EVEX2003 HDBaseT™ Extender (330ft/100m) www.vanco1.com • 800.626.
DEAR CUSTOMER Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully before connecting, operating or adjusting this product. Please keep this manual for future reference. This product is 100% inspected and tested in the United States to verify HDMI performance parameters. WARNING 1. Do not expose this unit to water, moisture, or excessive humidity. 6. Only clean unit with a dry cloth. 2.
FEATURES INTRODUCTION The EVEX2003 HDMI Extender over Single Cat5e/6 with HDBaseT Technology, Bidirectional IR, and PoE extends high definition video and audio signals, IR, and power at a distance of up to 330ft/100m over a single Cat5e/6 cable. 4K2K (2160p) resolution compatible, and can be extended up to 262ft/80m. Features HDBaseT Technology that allows for greater transmission range compared to standard HDMI extenders.
HDBaseT Extender 330ft/100m Part # EVEX2003 • Features HDBaseT Technology, optimized for whole-home or commercial distribution of uncompressed high-definition signals at twice the distance of HDMI cables without degradation • HDBaseT Extender can connect uncompressed full HD digital video, audio, 100BaseT Ethernet, and various control signals through a single 330ft/100m Cat5e/Cat6 cable • Features Power over Ethernet (PoE) Technology which transmits power over Cat5e/6, allowing for either Transmitter or
SPECIFICATIONS TECHNICAL SPECS HDMI Compliance....................................................... HDMI Deep Color, Full 3D 4K2K @ 30 HDCP Compliance....................................................... Yes Video Bandwidth......................................................... Single link 340 MHz (10.2 Gbps) Video Support............................................................ 480i/480p/720p/1080i/1080p @60/2160p@30 HDMI over UTP...........................................................
PACKAGE CONTENTS • • • • • • EVEX2003 (TX and RX) IR Blaster (TX) IR Receiver (RX) (1) DC 24V in line power supply Rack-mounting ear set Product Manual PANEL DESCRIPTIONS Transmitting Unit 1 2 3 Receiving Unit 4 5 7 6 8 9 10 11 12 16 13 14 17 18 1. 24 V DC 10. 24 V DC 2. Power indicator 11. Power indicator 3. HDMI IN 12. HDMI OUT 4. IR Blaster 13. IR Blaster 5. IR Receiver 14. IR Receiver 6. Mini USB (for Firmware Updates) 15. Mini USB (for Firmware Updates) 7. LAN PORT 16.
CONNECTION DIAGRAM CONNECT AND OPERATE 1. Connect a source such as a Blu-Ray Player, game console, A/V Receiver, Cable or Satellite Receiver, etc. to the HDMI input on the Transmitting unit. 2. Connect a display such as an HDTV or HD Projector to the HDMI output on the Receiving unit. 3. Connect a single Category 5e/6/7 up to 330ft/100m to the HDBaseT output of the Transmitting unit, and the other end to the HDBaseT input of the Receiving unit. 4.
IR PASS-THROUGH IR Blaster TX IR Receiver RX IR BLASTER (TX) To control the source: Plug IR Blaster into IR TX port of transmitter unit (EVEX2003-TX); place blaster in front of the IR eye of the source. To control the display: Plug IR Blaster into IR TX port of receiver unit (EVEX2003-RX); place blaster in front of the IR eye of the display. IR RECEIVER (RX) To control the source: Plug IR Receiver into IR RX port of receiver unit (EVEX2003-RX); place receiver at or near display.
NOTICE 1. Vanco HDMI and Cat5e/6 cables are strongly recommended for use with this product to ensure best results. 2. Incorrect placement of IR Blaster and Receiver may result in the failure of the IR extenders. Please check carefully before plugging in the IR extender to the respective IR sockets. 3. The transmission length is largely affected by the type of Cat5e/6 cables utilized, the type of HDMI sources, and the type of HDMI display.
TROUBLE-SHOOTING 1. Best results are usually achieved when the source and display resolutions are the same. If resolutions differ, the extenders will try to adjust the signal to match the resolution of the HDTV with the lowest resolution. This will result in a picture with a lower resolution on the other HDTV sets. 2. If you do not get audio and video, access the “setup” menu on the TV to adjust the audio and video settings.
LIMITED WARRANTY With the exceptions noted in the next paragraph, Vanco warrants to the original purchaser that the equipment it manufactures or sells will be free from defects in materials and workmanship for a period of two years from the date of purchase. Should this product, in Vanco’s opinion, prove defective within this warranty period, Vanco, at its option, will repair or replace this product without charge. Any defective parts replaced become the property of Vanco.
® Vanco International 506 Kingsland Drive Batavia, Illinois 60510 call: 800.626.6445 fax: 630.879.9189 visit: www.vanco1.
