User Manual

www.vanco1.com

800.626.6445

IR RECEIVER EXTENSION

If a longer IR Receiver run is desired, the IR Receiver pigtail can be extended two ways:

1.Cutting and splicing the cable.

This is a traditional method in which the IR Receiver cable is cut and spliced into a longer length cable such as

a 3 conductor cable or category cable. For reference, when cutting the IR Receiver cable, here are the color

codes for each wire:

Tip = White = Signal

Ring = Red = Power

Sleeve = Black = Ground

2.Utilizing the optional IR 3.5mm In-Line Jack (part #s 280752 and/or 280753)

• Installing (2 qty) IR jacks alows for a much easier and cleaner installation

• The jacks allow the IR Receiver to be plugged into the 3.5mm jack, and on the other side are spring

loaded terminals to directly connect a 3 conductor cable or category cable. The second jack would

require a stereo cable to be connected to the Connecting Block.

Part # 280753

Part # 280752