IR DISTRIBUTION Three Zone Six Source IR Kit Vanco Part Number EV-IRKIT6 Three Zone Six Source IR Kit www.vanco1.com • 800.626.
DEAR CUSTOMER Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully before connecting, operating or adjusting this product. Please keep this manual for future reference. WARNING 1. Do not expose this unit to water, moisture, or excessive humidity. 2. Do not install or place this unit in a built-in cabinet, or other confined space without adequate ventilation. 3.
FEATURES INTRODUCTION The Evolution by Vanco EV-IRKIT6 Three Zone Six Source IR Kit allows for controlling multiple sources from multiple displays, remotely via IR. Have concealed source equipment controlled by up to three separate display locations. The EV-IRKIT6 features a low profile receiving pigtail with a confirmation led notification, expandable up to two more receiving pigtails for additional zones.
SPECIFICATIONS Receiver Frequency Range........................................... 34 kHz to 60 kHz, RC-MM codes Emitter Frequency Range............................................. 38 kHz to 56 kHz Receiving Distance...................................................... 25ft Emitting Distance....................................................... 4-8in Power Consumption.................................................... 12VDC, 30mA max Dimensions Connecting Block...........................................
CONNECT AND OPERATE Connect the provided dual-IR emitter to one of the numbered “IR Emitter” ports on the connecting block Locate the IR eye window on the source device. This can usually be seen when using a flashlight pointed at the front of the source at an angle or can be found in the product’s user manual. Place or stick each IR emitter onto the sources such as a Bluray player, cable or satellite box, etc. See the illustration above for correct IR emitter placement on sources.
IR RECEIVER EXTENSION If a longer IR Receiver run is desired, the IR Receiver pigtail can be extended two ways: 1.Cutting and splicing the cable. This is a traditional method in which the IR Receiver cable is cut and spliced into a longer length cable such as a 3 conductor cable or category cable. For reference, when cutting the IR Receiver cable, here are the color codes for each wire: Tip = White = Signal Ring = Red = Power Sleeve = Black = Ground 2.Utilizing the optional IR 3.
LIMITED WARRANTY With the exceptions noted in the next paragraph, Vanco warrants to the original purchaser that the equipment it manufactures or sells will be free from defects in materials and workmanship for a period of two years from the date of purchase. Should this product, in Vanco’s opinion, prove defective within this warranty period, Vanco, at its option, will repair or replace this product without charge. Any defective parts replaced become the property of Vanco.
® Vanco International 506 Kingsland Drive Batavia, Illinois 60510 call: 800.626.6445 fax: 630.879.9189 visit: www.vanco1.
