Installation & Assembly

4
Door
Height
INSTRUCTIONS
This procedure should be done so that when the
doors go on the track it will slide smoothly above
that highest point of the floor.
REMINDER: Make sure your floor is level. If
not, please measure the distance from the
highest point of your floor.
Draw a horizontal line using the following formula
(1/2” + Door Height + 1 1/2”). This line will be
used to line up horizontally to the center of the track.
Find all the studs and then lay your track onto
the wall. Make sure the line you drew previously
lines up horizontally to the center of the track
and each hole is on the studs location. Then
mark the center of the holes position.
1. Drill the previously marked holes and install
the lag bolt and spacer onto the first hole as shown
in the
picture.
2. Install the door stoppers on an approximate
position where you want the doors to stop.
3. Repeat the same process for the remaining
holes.
Notice: The reason of installing the door stoppers
before mounting the second hole is to avoid taking
off the already installed bolts and spacers if you
decide to install the stoppers between the two
holes. The door stoppers position is adjustable
between the two holes using the hex wrench.
REMINDER: Depth of track to wall is 1 3/8”.
If you have a door trim be sure to use a header that
has the same thickness of your trim before installation
of the track or a second option would be a 3/4”
spacer extenders which we can offer when
requested so the door can clear off the door trim
when sliding. Also if your track cannot line up to the
studs be sure to use a header board for safety purposes.
CAUTION:Do not over tighten when installing
the track on any drywall surfaces or you may
be at risk of damaging your drywall.
If your track comes in 2pcs
or more, install the junction
plate on to each two tracks
like the diagram shown here.
homacer