Installation Guide

Tool Setup-Brakes (cont.) 3-
1
1
/
2
”
4
Place rail L alongside right bracket K with 5/16” hole to
front of brake. Slide hex head portion of screw D down
track and extend through 2nd hole from end of bracket K
as shown (see center arrow). Start knob F onto threads and
leave loose for now. Repeat this procedure with remaining
rail L and left bracket J.
5
Align front hole in rail L with front hole in bracket K.
Insert Fast Pin A through front hole in rail, then through
bracket. Repeat this procedure with remaining rail L and
bracket J.
6
Start knob F 2 or 3 turns onto the threads of a hex head screw
D. Slide hex head portion of screw into track of rail L 1 ”
and leave loose. Repeat this procedure with remaining rail L.
7
Ensure left & right rails L are 34 ” apart to receive
the slotted brackets on bottom of tool. After aligning
the slots with knob threads, slide tool onto rails until slot-
ted brackets are FLUSH with ends of both rails (see Detail
F). Tighten knobs on both sides. Ensure rails and brackets
are positioned squarely on brake then tighten all fasteners,
knobs F and locknuts H securely in place. Check all fasten-
ers and knobs often and tighten as needed.
8
Install the roller handle over the handle plugs and insert
short fast pins B through holes. Reverse procedure to
remove handles when tool is being stored or transported.
9
To install the bending leaf handle, align holes in ends of
tube with holes in handle plugs. Insert short fast pins B as
shown.
Metal Master
®
20 Setup
Flush
Flush
Mounting
Rail Track L
Bracket K
Brake
Rail Track
1
Slide two hex head screws C into tracks in bottom
of brake rail. Extend bracket K over screw threads
and tighten with knobs E. Ensure bracket K is FLUSH
as shown. Slide two hex screws C into mounting rail
track L and through holes in bracket K. Tighten rmly
with lock nuts G. Repeat procedure on opposite side
of brake facing away. Note: Use illustration below for
assistance.
2
Start a knob E onto a hex screw C and slide into mount-
ing rail track approximately 2 inches. Loosen slotted
brackets from under tool and slide even with mounting rails
keeping tool centered between the mounting rails. Slide the
slotted brackets over the screws until FLUSH with mount-
ing rails. Tighten knobs E securely. Now tighten lock nuts
G. To remove tool, loosen knobs E and slide off from
mounting rails.
Go online or click the link below for
additional Instructions, Tips and How To’s
http://www.van-mark.com/Roong/TrimAGutt/tag_over.html
3
Firmly tighten all knobs E and lock nuts G. Install the rolling handle and the bending leaf handle to complete the setup of the tool. Check the tool often for looseness and tighten as needed.
Make sure the tool is free from dirt and debris which can damage tool and mar material. Do not lean against tool as tipping or damage can occur. Do not use the reinforcement clip when
working with standard trim coil. Refer to step 4 Forming Gutter-Hood for instructions on using the reinforcement clip to make hood from stiffer gutter-coil material. Note: Except for the
special instructions seen above for mounting Trim-A-Gutter
™
to the wider 20" throat brakes, all other instructions should be followed.
Track
Slotted
brackets go outside of rails
Detail F
Remove tool from brake before moving or transport-
ing around job site. Do not lean on tool as tipping will
occur causing injury or damage to machine.