Specifications

Manual Van de Leur Audio 002

First use

Before first use, ensure volume control is fully turned to the left and that the power switch on

the rear is set to off (O). Connect the pre amplifier to a power amplifier (like Van de Leur

Audio 402) and connect all audio sources. All connections on the amplifier are unbalanced

(cinch) plugs. Use high quality cables for optimal safety and audio performance.

After connecting all the sources, connect the amplifier to your power source. Make sure the

power connection is solid and can not be disconnected accidental. Switch the power on with

the switch on the rear panel (position I). The LED on the front will light RED. Touch the

power button on the front to power on the amplifier. The LED will turn LIGHT BLUE during

start up. After approximately 30 seconds, the amplifier will be active and the LED will turn

BLUE.

LED RED – Power is connected, amplifier is turned off.

LED LIGHT BLUE – Amplifier is powering on, start up phase, no audible sound.

LED BLUE – Amplifier is fully powered on.

Front panel

Volume is controlled by the large knob on the front panel. Turn it to the right to increase

volume. Turn it to the left to decrease volume. You can also use the provided remote control

to control volume.

Balance is controlled by the smaller knob next to the volume control. Use this to correct

small balance issues in your setup. The stereo focus will shift according to the position of the

knob.

Input selection is controlled with the far most right selector. Turn the knob to the right input

to enable audible sound from this input.

P – Phonostage playback (both MM/MC)

2, 3, 4 and 5 – Line inputs corresponding to similar named inputs rear panel

D – Direct out (home theatre pass through)

Power switch is operated by touch. Firmly press your finger on the button to switch on or off.

Headphones can be plugged in to the left headphone socket indicated: Phones. Use jack

plug. Output is switched off when operating in headphone playback.

Rear panel

Power socket IEC connector. Use this socket to connect your amplifier to mains. The

compartment underneath the input contains a fuse, including a spare fuse. Do not open this

compartment while having the amplifier connected to mains. Remove the power cord before

opening this compartment.

Power switch is located next to the IEC connector, use switch to fully turn off power.