Instructions / Assembly

Step 9: Screw Motor Bracket into correct position by removing

proper motor screws, placing Motor Bracket in desired position

and rethreading screws. Reposition Motor over top Handle

Mount disc as shown in Step 5.

Step 10: Hold Pipe Mount Bracket in desired

location such that Connecting Rod passes

through the hole in the Pipe Mount Bracket.

Step 11: Install proper size U Clamps around

pipe and through the slots on the Pipe

Mount Bracket. Use smallest U Clamps that

will fit around the pipe. Fasten Pipe Mount

Bracket to pipe by screwing down four ¼ inch

nuts to the U Clamps.

DO NOT OVERTIGHTEN NUTS.

Step 12: Slip Cotter Pin through

hole on top of Connecting Rod

to secure Motor to valve

handle.