Instructions / Assembly

Step 4: Twist on and tighten

#4 lock nuts to # 4 screws on

bottom Handle Mount Disc.

Step 5: Place Motor over top Handle Mount disc such that

Motor drive lines up with the shaft on the top Handle Mount

Disc.

Step 6: Position Motor Bracket such that it will be able to

line up with Pipe Mount Bracket after the Pipe Mount

Bracket is installed. Refer to “What it should look like”

picture above (Figure A).

Motor Mount

Bracket

The Motor Bracket contains a number of holes and

is shaped so that it can be mounted to the right

side, left side or front of Motor. It can be mounted

on the top or bottom of Motor. Choose the position

that works best.

Step 7: Screw ¼ in Bolt or

Threaded Rod (depending

upon model) through top

center hole on Motor Bracket.

Step 8: Hold Pipe Mount

Bracket and Motor Bracket in

desired positions so that the

Bolt or Threaded Rod will easily

pass through the hole in Pipe

Mount Bracket. Then insert

plastic grommet.

Pipe Mount

Bracket