Instructions / Assembly

Battery Installation:

The ValveSentry Device is operational with the batteries installed. THEREFORE,

FOR YOUR SAFETY, INSTALL BATTERIES AS YOUR LAST STEP AFTER THE DEVICE HAS

BEEN INSTALLED ON THE VALVE TO BE CONTROLLED.

• Mounted Device: Install 7 AAA batteries in the mounted device’s battery compartment.

Low Battery Feature: The ValveSentry device makes a chirping noise when the batteries need replacement. This indicates that the device will

not properly operate. To ensure that the device functions properly replace batteries when chirping occurs.

Battery Replacement: Batteries should be replaced every year to assure it functions properly. This should be done even if the device makes no

chirping noise warning you to replace the batteries.

DANGER: The ValveSentry™ device is powerful. It has considerable torque allowing it to open and shut your valve. THEREFORE ALWAYS KEEP

YOUR HANDS AND FINGERS AWAY FROM THE DEVICE while it is powered. If your hand or finger gets caught on a valve or is between the valve

and a pipe, wall or other object while a valve is opening or closing, it could cause injury. That is why you should always unplug and remove the

batteries from the unit prior to installing, adjusting or touching it. Remember that you can always immediately shut down the unit by pressing

the “stop” button on the controller.