Operating instructions

13
IX. Trouble-shooting...
Symptom Possible Cause Corrective
Action
LCD does not show display No power to laminator Close panel breaker
when heat switches are on.
Blown fuse Disconnect power and
replace fuse
Film is not bonding to the print Laminator not set to optimal Adjust temperature
slightly laminating temperature upward.
Ink on print is wet Allow ink to dry
thoroughly
Paper is too slick Use a more matte
paper
Laminated item curls Top or bottom film tension Loosen tension on
side is too high. (top or
bottom) film is
curling toward.
Laminated item is wrinkled Mandrel tension too loose Increase mandrel
tension on
side (top or bottom)
that has wrinkles
Temperature too high Reduce temperature
Moisture in paper being Store paper in dry
area
Laminated.
Laminated item is blistered Temperature too high Reduce temperature
Mandrel tension does not remain Brake screw improperly Tighten screw
constant adjusted
Core gripper blade is not Rotate film core
preventing the core from while holding
the spinning on the mandrel mandrel firm
to lock
the blade into the core
Too much heat with a lower Bottom roller sensor not Ensure bottom roller
Indicated heat readout on LCD touching sensor is touching
core.