Instruction manual

❍ 4. Test fit the aileron servo in the 3mm plywood aileron
servo tray. If necessary, trim the opening in the tray to
accommodate the servo. Once you are satisfied with the fit of
the servo, remove it from the tray and set it aside for now.
❍ 5. Measure the width of your servo. Mark and cut 1/2 of
this distance from the sheeting over the aileron servo
mounting area in both wing panels to accommodate 1/2 of
your aileron servo.
❍ 6. The servo will be centered in the wing after the two
panels are joined. Test fit the servo into the cutout of both
the wing panels. Trim the root rib if necessary to
accommodate the servo and the servo wire. Prepare the
left wing panel the same way.
❍ 7. Trim the covering from the ends of the root ribs on
both wing panels. This is easily done with a sanding block
and medium-grit sandpaper as shown. Do both wing
panels at this time.
❍ 8. Draw a centerline on both sides of the plywood wing
joiner as shown.
❍ 9. Locate the two 8mm square x 38mm aileron servo
tray mounting blocks. Mark a centerline on each block.
Using the wing joiner as a guide, mark the wing dihedral
angle on both of the aileron mounting blocks. Trim and
sand to shape at this time.
Set the blocks aside for now.
5