Instruction manual

❍ 1. To complete this step you will need the following items

as shown in the photograph above.

#1 Fuselage (1)

#2 Main Landing Gear (2)

#3 Nose Gear (1)

#4 Wheels (3)

#5 4mm x 12mm Phillips Head Screws (2)

#6 Nose Gear Bearing Block (1)

#7 4mm Wheel Collars (8)

#8 3mm x 8mm Phillips Head Set Screw (1)

(For Nose Gear Steering Arm Only)

#9 3mm x 5mm Phillips Head Set Screw (7)

#10 4mm Flat Washers (2)

#11 Landing Gear Straps (2)

#12 3mm X 10mm Phillips Head Wood Screws (4)

#13 Nylon Steering Arm (1)

#14 Screw Lock Pushrod Connector Assembly (1)

❍ 2. Test fit the two main landing gear wires into the

pre-drilled holes inside the channel located in the bottom

of the fuselage. If they will not go in easily, drill out the two

holes using a 5/32” [4mm] drill bit. Next, use the drill bit or

hobby knife to bevel the inside corners of the holes so that

the bend in the wire will seat fully into the holes and the

wire will be flush with the bottom of the fuselage. Place the

landing gear wires into the channel. Look carefully and you

will find four pre-drilled holes under the covering. They can

be seen in the photograph.

❍ 3. At the locations of the pre-drilled holes attach the

nylon landing gear straps to the fuselage using the four

3mm x 10mm Phillips head wood screws and the nylon

landing gear straps as shown in the above photograph.

MOUNT THE LANDING GEAR