Instruction manual

❍ 1. To complete this step you will need the following items

as shown in the photograph above.

#1 Fuel Tank (1)

#2 Clunk (1)

#3 Fuel Pickup Tube (1)

#4 Vent Tube (1)

#5 Fuel Line for Pickup (1)

#6 Stopper with Hardware (1)

#7 Fuel Line (1)

Note: The fuel tank parts shown in the photo are placed

inside the tank at the factory.

❍ 2. Assemble the stopper, tubes, and clunk as shown

in the photograph. Bend the vent tube so it is just below

the top of the tank and then insert this assembly into in the

tank. Tighten the screw to expand the stopper, thus sealing

the tank. Be certain the clunk at the end of the fuel line

inside the tank does not contact the rear of the tank.

Otherwise, the line may become stuck above the fuel level

and discontinue fuel flow.

Remember (or use a felt-tip pen to mark) which tube is the

fuel pick-up tube and which tube is the vent (that will be

connected to the pressure fitting on the muffler). Place the

fuel lines on the vent and fuel pick-up tubes at this time.

❍ 3. Install the tank in the fuselage with the neck of the

tank inserted into the hole in the firewall. Secure the tank

into place with RTV silicone or Zap-A-Dap-A-Goo

(PAAR3200) around the stopper. Then slip the tank into

place. Also put a bead of silicone around the stopper on

the front of the firewall.

INSTALL THE FUEL TANK