Instruction manual

MOUNT THE STABILIZER AND FIN

❍ 1. In order to complete this section you will need the

following items as shown in the photograph above. You will

also need the wing (not shown) for alignment purposes.

#1 Fuselage (1)

#2 Stabilizer (Stab) (1)

#3 Elevator (1)

#4 Fin (1)

#5 Rudder (1)

#6 CA Hinges (7)

❍ 2. Test fit the hinges into hinge slots in the stabilizer

and elevator and the fin and rudder. If necessary insert a

#11 blade into the hinge slots and run it back and forth to

enlarge them slightly.

Important Note: Remember to insert the hinges with the

cut running the correct direction.

❍ 3. Use a hobby knife with a sharp #11 blade and cut the

covering from the openings on both sides of the fuselage for

the stab. Also cut the covering from the opening in the top of

the fuselage for the fin. Remove the elevator from the stab.

❍ 4. Taking accurate measurements, locate the center of

the stab along the trailing edge. Slide the stab into the

fuselage and center it over the aft end of the fuselage.

Insert a T-pin through the stab and into the fuse at the

location shown in the photograph above. This will hold it in

place but will still allow for correct alignment.

ASSEMBLE THE FUSELAGE