User Manual

 Single Fire Operation
SINGLE SEQUENTIAL MODE
The tool is specially designed for single sequential mode. This mode requires the trigger to be pulled each time a
fastener is driven. The tool can be actuated by depressing the work contact element against the work surface followed
by pulling the trigger
The trigger must be released to reset the tool before another fastener can be driven.
 Clearing Jammed Nails/Staples
A jammed nail or staple must be cleared before using the nailer/stapler again.
 To clear a jammed nail or staple from the magazine:
1. DISCONNECT THE NAILER / STAPLER FROM THE AIR SUPPLY!
2. Unlock the catch lever and pull the magazine pusher back completely.
3. Locate and remove the jammed nail/ staple with a pair of needle nose pliers.
4. Throw the damaged nail/staple away.
5. Inspect the nail/staple stick. If it is bent or damaged, throw it away and insert a new stick that only contains clean,
undamaged nails/staples. DO NOT use dirty or damaged nails/staples!
6. Push the magazine pusher forward to the front of the magazine until the catch lever locks.
 To clear a jammed nail from the discharge area:
1. DISCONNECT NAILER /STAPLER FROM THE AIR SUPPLY!
2. Unlock the catch lever and pull the magazine pusher back completely.
3. Remove the nail/staple stick from the magazine.
4. Pull up on the latch and open the jam release.
5. Insert a flat blade screwdriver into the driving mechanism
and push the driver mechanism back,freeing the jammed
fastener.
Figure 7. Opening cover to clear a jam.
6. Remove the jammed fastener.
7. Inspect the nail/staple stick. If it is bent or damaged,
throw it away and insert a new stick that only contains clean,
undamaged nails/staples.
DO NOT use dirty or damaged nails/staples!
8. Close the jam release and latch.
9. Reconnect the tool to the air supply.
10. Reinstall fasteners.
WARNING!
Potential hazard that could result in serious injury or loss of life.
Disconnect the magazine from the tool and remove the non-jammed fasteners from the tool before
clearing a jammed fastener. The fasteners are under pressure and failure to comply will cause them to be fired out
of the tool causing serious injury.
Do not point the tool towards the operator or other people. Serious personal injury could result if these
instructions are not followed.