User Manual

 OPERATING INSTRUCTIONS
 To load your nailer/stapler:
1. DISCONNECT NAILER /STAPLERFROM THE AIR SUPPLY!
2. Grip the nailer/stapler firmly, unlatch the catch lever (Figure 3), and pull the magazine pusher back completely.
Figure 3. Catch lever engaged and magazine pusher retracted.
3. Insert a strip of brads or staples, pointed-end down, into the magazine as shown in Figure 4.
Only those fasteners specified under TECHNICAL DATA may be used
Figure 4. Loading nails into magazine.
4. Slide the staples or brads all the way down to the nose of the nailer/stapler.
 For brad nail: Insert a stick of fasteners into the magazine rail (D).Make sure the pointed ends of the fasteners
are resting on the bottom ledge of the magazine when loading.
 For staples: set a stick of fasteners on the top of magazine.
5. Push the magazine toward the nose of the nailer/stapler until the catch lever locks.
6. Reload the nailer when the magazine sight window (Figure 4) shows the nail or staple level is low. The
sight window shows up to approximately 50 nails or staples loaded.
Magazine
Pusher