Specifications

9
5. Swing the bottom of the mantle back. The mantle
connecting brackets should be outside the heater sides. Align
the holes in the brackets with the threaded holes in the
heater sides. Fit the two machine screws supplied and
tighten. See figure 9.
Note If the mantle sides are not square with the top, they can be realigned
by loosening the hexagonal bolts connecting the cross grills (See figure 10).
CONTROL OPERATION CHECK
Check the pilot ignition and thermostat control operation - See
Lighting instructions.
Figure 9 Mantle lower connections
Figure 10 Mantle side/grill bolts (for realigning sides)