Specifications

8
FITTING CAST-IRON MANTLE
1. Remove the two rectangular plates at back of the casting near
the bottom (see figure 7). The plates and washers will not be
needed for this appliance but save the screws.
2. Fit the two mantle connecting brackets in place of the
rectangular plates using the screws removed from the plates
(see figure 7).
3. Pull off the sealing rope at back of the mantle (See figure
7A). This rope is not needed for the “Senator”
4. Lift the mantle. Hook the top of the mantle over the heater
unit so that the two flanges at back of the mantle top are
behind the channel at top of the heater unit (see figure 8).
Lower the mantle as far as possible to fully engage over the
heater.
Figure 7 Fitting mantle connecting brackets
Figure 8 Mantle top location.
Figure 7A Rope seal