User manual

Installation

Please

read

the manual before installation.

Before You Start

• Disconnect negative battery terminal. Consult a qualified technician for instructions.

• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight,

or where it would be subject to dust, dirt or excessive vibration.

Getting Started

• Insert the supplied keys into the slots as shown, and slide the unit out

the mounting sleeve.

• Install mounting sleeve into opening, bending tabs to secure.

• Connect wiring harness and antenna as shown on pages 5-6. Consult a qualified technician if you

are unsure.

• Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).

• Test for correct operation and slide into mounting sleeve to secure.

• Snap trim ring into place.

• Mount the adapter to any smooth clean surface using the supplied double-sided tape

#2 x 3/8" Phillips head screws.

Mounting sleeve opening dimensions

7-3/16" x 2-1/16" (183

x 53 mm)

KEYS

HEX

BOLT

ASHER

WASHER

HEX

NUT

PLAINW

SPRING

HEX

BOL

MOUNTING

SLEEVE

TYPICAL FRONT-LOAD DIN MOUNTING METHOD