Owner`s manual

OWNER’S
INFORMATION
7
Owner’s Information
b. Push the top of the screen against the top of the
window frame and while holding it bend the top
brackets around the window frame to secure the
screen. Check that the screen is solidly hooked
to the window frame.
Checking Pilot and Burner Flames
A periodic check of the pilot and burner fl ames should
be made. Check after the fi re has been on for at least
30 minutes. The pilot fl ame must cover the tip of the
thermocouple probe. The main burner fl ame pattern will
vary from appliance to appliance depending on the type of
installation and climatic conditions—see images below.
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids. Inspect the vent terminal
outdoors regularly to make sure that, snow, leaves,
bushes, trees, etc, do not obstruct it. Examine the vent
system and terminal regularly. We recommend annually.
a. Hook the window over the top
edge of the fi rebox, and
fasten the bottom two
spring- loaded bolts
by pushing in and
turning them 90
degrees.
b. If the Hot
Glass
Warning
plate has been removed from the front
lower corner of the window, reinstall it by
sliding it between the glass and the frame as
indicated.
8. Reinstall the barrier screen.
a. Hook the bottom of the screen to the bottom
edge of the window frame and then push the
screen against the window frame.
Pilot Flame
Thermocouple
Probe must be
in Flame
Correct Flame Picture
Spring-loaded
Fastening Studs (2)
1/4 Turn
Hot Glass Plate
WARNING
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the fi replace window
after maintenance.
WARNING
!
Top view—Hook bottom of screen to bottom of
window frame
Convection baffl e