Owner`s manual

20
Re-install Burner Module
Note: If the circulating fan is to be installed it
should be done at this point before installing the
burner module. See instructions packaged with the
fan for details of the fan installation.
Reinstall the burner module using the 4 screws
removed previously.
Note: The upper baffl e may be removed to gain more
room for the screwdriver to install the rear screws.
Level Appliance in Hearth
The backside of each support leg has a leveling bolt. If
necessary, adjust the level of the fi rebox in the hearth.
Leveling
bolt
Front View
Side View
Fret bracket
Leg
Leveling bolt
BackFront
Leveling
bolt
Connect Gas Line and Test Appliance
Connect the gas line to the burner module. Check
for leaks, purge the line, and test-fi re the unit before
installing the window or proceeding with the remainder
of the install—see Lighting Instructions section.
Re-install Top Baffl e (if removed)
Reinstall Burner
Module (4 screws)
Edge Fits into
Cleat at Back
Remove Top Baffle
(2 screws)
Remove Top Baffle (optional)
(to provide space for a screwdriver)
Edge fits into
Cleat at Back
of Firebox
Reinstall Top
Baffle (2 screws)
Installation
QUALIFIED
INSTALLER