Owner`s manual

18
Installation
Remove Vent Plate
Remove Window
Remove
Burner
Module
(4 screws)
Remove
Support Legs
(2 screws each)
Spring-loaded
Fastening Studs (2)
1/4 Turn
Prepare Appliance
The size of the existing fi replace cavity will affect the
method of installation. Smaller fi replaces, particularly
factory-built zero-clearance fi replaces will require the
RF24 fi rebox to be disassembled then reassembled
inside the fi replace. Plan your particular installation
accordingly.
1. Unpack appliance.
2. Remove window.
3. Remove log pack from fi rebox.
4. Strip fi rebox down by removing:
a. Burner Module (4 screws),
b. Vent plate (2 screws);
c. Support Legs (2 screws per leg) (required
when inserting into small fi replaces only)
Remove Window
3” dia. Aluminum Liner
Rough-in Vent Liner
Rough-in the 3” diameter vent liner into existing
chimney system being careful not to tear or damage
the liner in the process. Leave plenty of liner at the
bottom end if the heater will be connected while on the
hearth—see diagram.
Existing Fireplace Rough-In Liner
When connecting the liner in this manner, it is best to
leave the top termination until later so the slack liner
can be lifted after the insert is in place.
QUALIFIED
INSTALLER