Owner`s manual

19
Remote Control Operation

 a screwdriver or other metallic object
to remove the batteries from the receiver or the
handset! This could cause a short circuit to the
receiver.

Use this setting when you come in and want to enjoy a specic temperature.
1. Push the  button until a number and  ash. Let go.
2. While it is still ashing, push the ▲ and ▼ buttons to the temperature you want.
Let go.
Your replace will reach that temperature and the remote will check the temperature
every ve minutes, adjusting the amount of fuel needed to give you a steady, even heat.

Use this setting when you want a particular ame level. For instance, you want to
watch ames burn at their highest level and you don’t mind if the room is too hot.
1. To raise the ame, press and hold the ▲ button until the flame gets to the desired
level. Let go.
2. To lower the ame, press and hold the ▼ button until the ame gets to the
desired level. Let go.
The  will remain just as you set it.

You can set your replace to come on before you wake up and turn off after you leave
and then, turn on again just before you come home and turn off after going to bed.
You can leave it like this for the heating season.
1. Decide what temperature you want your replace to be at. Also, decide what time
you want your replace to turn on and off. Finally, decide what time you want it to
come back on and off in the afternoon or evening. For the rst few times you set
the timer, it’s handy to write these times down.
2. Set the temperature (just as you did in the section Setting the temperature.)
3. Press the  button and hold it until 
 appears and flashes. Let go.
While ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at
which you want your replace to turn on in the morning.
4. Press the  button and hold it until ☽ appears and ashes. Let go. While
ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at which you
want your replace to turn off when you leave.
5. Press the  button and hold it until 
 appears and ashes. Let go. While
ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at which you
want your replace will turn back on in the afternoon.
6. Press the  button and hold it until ☽ appears and ashes. Let go. While
ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at which you
want your replace to turn off in the evening.
7. That is all you have to do. Your replace will give you steady, even heat at the
temperatures and times you set.
Note: If you want to set your replace for only one time on and off, set 
 and ☽
for the same times as ☽. The remote will record the ☽ off time for both times.
To temporarily override the timer setting, just press  or ▲ and ▼ to go back to
manual settings. Press  to go back to your settings.

When your remote control displays , you need to
replace the battery with a new 9 volt alkaline battery—
6LR61/MN1604.