Owner`s manual

12



Reinstall the burner module using the 4 screws removed previously.
Note: The upper bafe may be removed to gain more room for the screwdriver to install the rear screws.

Connect the gas line to the burner module. Check for leaks, purge the line and, test-re the unit before installing the win-
dow or proceeding with the remainder of the install. See Lighting Instructions section.
 (if removed)

Position the rebox 
to allow ample space at the
front for the fret.
Position the top convection bafe with the threaded
studs pointing downwards into the slots at the top of
the rebox.
Slide the convection bafe as far forward as
possible and tighten the wingnuts.
Reinstall Burner
Module (4 screws)
Edge Fits into
Cleat at Back
Remove Top Baffle
(2 screws)
Remove Top Baffle (optional)
(to provide space for a screwdriver)
Edge fits into
Cleat at Back
of Firebox
Reinstall Top
Baffle (2 screws)
Convection Baffle
Wingnuts(2)
Start Wingnuts an Studs.
Slide Convection Baffle
into slots. Adjust
Baffle Forward to Touch
Back of Smode Curtain of
Existing Fireplace.
Tighten Wingnuts.
Firebox Installation