Installation manual

16 Valor Hamlet Multifuel Stove
SERVICING & MAINTENANCE
FIRE DOOR GLASS
In the event of the door glass being broken it can
easily be replaced. This should be done when the
appliance is cold and unlit:
•The door(s) should be lifted off the hinges so that
the below operations can be carried out on a
workbench or similar level surface.
•Unscrew the hex bolts on the inside face of the
door, using a 8mm socket or spanner. Remove the
retaining clips, see Fig. 13.
•Carefully remove any pieces of broken glass, and
sealing gasket wearing suitable gloves.
•Re-place the gaskets and line them up in
relation to the door frame. See Fig.13.
•Re-seat the new glass, ensuring the sealing gasket
is flat and in contact with the glass. See Fig.14.
•Replace the two retaining clips and bolts. Do not
over-tighten the bolts as damage may occur to the
glass, see Fig. 15. Re-place the door(s) carefully
over the hinges and slot in place.
Fig. 12. Inner Slider Removal
Fig. 13. Lining up the gasket
Fig. 14. Fitting The Glass
Fig. 15. Tightening The Glass Clips
Fig. 16. Finished Door Assembly