User manual

VOL up

VOL down

Increase the volume

Decrease the volume

Smart Dial

Press this encoder to access system setup.

Rotate up/down to select a desired item and

press once to access or confirm.

NOTE: The buttons of NAV MENUF1\F2\F3\F4\F5\F6 are used on the navigation mode. If your

unit has the navigation function, please read the user manual of navigation to find the functions

of the buttons.

TFT Monitor Operation

Open/Close TFT Monitor

Press the ( ) button on the front zone remote control or press the ( ) button on the

front panel to open/close the monitor.

TFT Monitor Auto Open

•If “TFT Auto Open” is “On”, when the unit is turned on, the monitor automatically opens to the

last viewing position.

•If “TFT Auto Open” is ”Off” , when the unit is turned on, press the ( ) button on the remote

control or press the ( ) button on the front panel to open the monitor into the desired

viewing position.

•If “TFT Auto Open” is ”Manual”,when the unit is turned on or turned off, the monitor has no

Movement.

See “General setting” for more instructions.

Monitor Tilt Angle Adjustment

The monitor angle can be adjusted for optimum viewing using one of the following methods:

• Press the ( ) button on the front panel to adjust the tilt angle of the screen one step at a

Time.

• Press and hold the ( ) button to continuously adjust the tilt angle.

• Adjust the “Screen Tilt” in the “Screen setting” to adjust the tilt of the screen to the desired

degree.

Rear Camera Mode

When the vehicle is placed in "Reverse", and an optional rear camera is connected to the unit,

the TFT monitor will automatically switch to the camera input source.

Image Setting

Video Output Format

The table below shows the video output format for each source.

Adjustable Parameters

While in RGB mode, the only parameter that can be adjusted is brightness (BRIGHT). To access

“SHARPNESS” “COLOR” “CONTRAST” “BRIGHTNESS” and “TINT ”you must be in CVBS

Mode.

SAT RGB Mode