Owner`s manual

- 12 -
4.11. Top Vent Connection, Horizontal
side termination
The vent pipe dimensional requirements in section 4.10
apply.
The minimum floor location is shown in figure 14.
Can be used with either #551DVK standard vent kit or
#984 Dura-vent terminal cap and accessories.
Adapter #817VAK, one 90° vent elbow #990B and
Dura-vent pipe lengths will be required.
(See venting options section of this manual).
4.12. Top Vent Connection, Horizontal
Side or Rear Snorkel Termination
The dimensional requirements in sections 4.10
and 4.11 apply.
Adapter #817VAK, one 90° vent elbow
#990B, a Dura-vent snorkel termination and
Dura-vent pipe lengths will be required.
#942 Dura-vent thimble kit may also be
necessary.
(See venting section of this manual).
4.13. Top Vent Connection,
Corner Location, Horizontal
Termination, 45° Pipe Run
The vent pipe dimensional requirements in
section 4.10 apply.
The minimum corner location is shown in fig.
15.
Can be used with either #551DVK standard
vent kit or #984 Dura-vent terminal cap and
accessories.
Adapter #817VAK, one 90° vent elbow #990B
and Dura-vent pipe lengths will be required. (See venting section of this manual).
Figure 14
Figure 15