User manual

VALOR
--------------------------------------------------------MULTIMEDIA---
A2DP
Pairing
Access the Bluetooth
"Setup"
screen and
select "Pair Mode"
to "Yes",
then
select
"Phone"
and
a "Waiting
to
pair"
message will
be displayed on the screen. Now you can begin pairing a phone
to the unit.
Once
your Bluetooth device has received the
signal
from the radio, then you
will see
the Bluetooth device name "VALOR"
displaying on the screen.
Select
Bluetooth device name
"VALOR" to begin the Bluetooth connection between your phone and the unit. This unit can
memorized up to 5
mobile
phones, but
only
one mobile phone can
be
used at a time. The Default
phone will
be retained only
if
all
other paired phones are deleted. (Default Phone: The phone that
was first paired with the unit.)
When using the maximum
limit
to pair phones, (for example four mobile phones have been
connected with the unit, and you want to pair a new one, then the system
will
retain the
last
paired phone as the system default phone) the phone
least used (except the
default phone) will
be
deleted
and the new paired phone
will
become the
last
phone.
Note:
The password to pair your phone with the unit is
"1234".
When asked/prompt, enter this
password on your phone.
Auto Connect
If the unit has been set to auto connect, it
will
attempt to connect to the last
used phone first.
If
Auto Connect is not activated, the unit
will
return to the previous operating mode.
When the phone connects to the unit
successfully,
the
cell
phone's Bluetooth features will
be
enabled.
Note:
Please make sure your phone's Bluetooth is
on
before turning
on
the unit.
If
your phone's
Bluetooth is turned
on
after the unit has been turned
on
you must pair the phone again
in
order to
connect.
37