Operating instructions

2828
Owner’s Information
Batteries
All appliances use four 1.5V AA batteries for remote control receivers and the handset uses a 9V battery.
Batteries are accessible by opening the bottom access panel and removing the lid of the remote control receiver.
Batteries should last one to two seasons, depending on usage. Removing batteries in the off season will extend
battery life.
Servicing
If you require any attention to your appliance, contact your supplier quoting the model number. It will be helpful if the
appliance serial number can also be quoted. This is on the rating plate, which is on a chained, plate accessible by
opening the bottom access panel.
The repair parts are shown in the separate repair parts leafl et. Please always quote part number and description
when requesting spare parts.
Setting the time
The fi rst thing to do is to set the time.
With your thumb, hold down both the AUTO and TIMER buttons until F fl ashes.
Let go.
Note the digital clock on the bottom right hand corner. The ▲ button sets the
hour; the ▼ button sets the minutes. Set the time.
Note: You must start setting the time while the F is fl ashing. If it stops fl ashing,
go back to 1.
The display shows °C/24-hour or °F/12-hour. To change the temperature/hour
display, press on the AUTO button while the display fl ashes.
Let go and wait until the fl ashing stops. The remote shows the time you set. It
also shows the current temperature.
Setting the temperature
Use this setting when you come in and want to enjoy a specifi c temperature.
Push the AUTO button until a number and F fl ash. Let go.
While it is still fl ashing, push the ▲ and ▼ buttons to the temperature you want.
Let go.
Your fi replace will reach that temperature and the remote will check the temperature
every fi ve minutes, adjusting the amount of fuel needed to give you a steady, even
heat.
1.
2.
3.
4.
1.
2.
Programmable Remote Control
Your fi replace remote control helps you get the comfort, convenience and
aesthetics you want from your gas fi replace. The remote controls your fi replace in
different ways.
IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the
settings of time, temperature and automatic ON/OFF can only be programmed
when the function display is fl ashing. Be patient when programming as it can
take a few seconds to set.