Operating instructions

2323

Aeration Setting Check

The burner is equipped with an adjustable shutter to control primary aeration. The shutter is factory set at

an aeration gap, which will give optimum performance for the vast majority of installations. In a few unusual

installations, performance may be improved by adjusting the aeration. The need for adjustment should be

determined by operating the appliance with the ceramic fuel effects and window installed. See the Operation Checks

section further on in this manual for adjustment details.

The shutter setting is very critical. A change of 1/64” can make a substantial difference to the performance.

Ceramic Walls Installation

The 530 engine is provided with a set of reversible walls. One side shows the brick pattern and the reverse side

shows a black vertical ﬂ uted pattern. Follow the instructions below to install the wall set on the chosen side.

Locate the ceramic rear wall in the channel at back of the ﬁ rebox and ﬂ at against the back of the ﬁ rebox.

Locate the sidewalls in the channels at the sides of the ﬁ rebox.

Remove two screws from under the top front of the ﬁ rebox. Using these screws ﬁ t the port cover.

1 32