Unit installation

! When replacing the switch make sure
that the white printing on the switch side
faces the back of the fire. If the printing
faces the front, pressing the upper half of
the switch will lower the flame height.
! When replacing, make sure that the
wiring loom runs above and down to the
right of the battery box and behind the
control valve (See figure 47).
! Secure the loom to the battery box
bracket with the cable tie supplied with
the new loom - check that there is
sufficient free length of loom wire to
allow the battery holder to be removed
from & replaced in the battery box
before securing the cable tie.
! The motor lead connectors are two
different sizes. They will only fit
to the correct motor terminals.
Page 37
INSTALLER GUIDE
Figure 48. Wiring diagram.
Figure 47. Switch and wiring loom removal.