Unit installation

16.2 To remove window unit.
! Remove the fascia (See section 16.1).
! Unscrew and remove the three spring-loaded window-
fixing screws and washers from the base of the window
frame (See figure 41).
! Gently swing the base of the window frame forward
while lifting the frame upward. The window should lift
clear of the fire. Put the window in a safe place away from
your immediate work area.
16.3 To remove the ceramic fuel effect and rear
wall.
! Remove the fascia (See section 16.1).
! Remove the window unit (See section 16.2)
! Lift out the ceramic fuel effect.
! Remove the rear wall by carefully sliding it upwards
to clear the retaining channel and then swinging the top
slightly forward.
16.4 To remove the complete burner module.
! Remove the fascia (See section 16.1).
! Remove the window unit (See section 16.2).
! Lift out the ceramic fuel effect and rear wall (See
section 16.3).
! Isolate the gas supply using the inlet ‘T’
connector on the appliance.
! Unscrew the nut from the top of the inlet
‘T’ connector.
! Detach the battery box from the fire unit
by removing two screws (See figure 42).
! Detach the burner front cover by
unscrewing the 10 screws at the front of the
burner module shown in figure 43.
! Slowly ease the burner module forward
and clear ensuring that the thermocouple
does not catch on the bottom of the firebox.
! Replace in reverse order.
! When replacing, make sure that the
wiring loom runs above and to the right of the battery box and behind the control valve
(See figure 44). The motor lead connectors are two different sizes. They will only fit to
Page 34
INSTALLER GUIDE
Figure 43. Burner module fixing screws.
Figure 42. Bracket may
differ from that shown
Figure 41.
Window fixing