Unit installation

14.2 Fitting the Chic fascia
! Remove any protective film from the
fascia.
! Locate the two lugs at the top of the
fascia in the slots in the convection box
hood. Swing the bottom of the fascia sides
back against the convection box and lower
the fascia so that the lugs are fully seated
in the slots in the convection box hood
(See figure 34).
! Secure the bottom of the fascia sides to
the convection box side brackets using the
two screws supplied (See figure 34).
! Supplied in the fascia pack are two
tubular trim sets. Hang these to the tabs on
the fascia (See figure 35).
! The lower section of the fascia is
secured with magnets. Locate it as in
figure 36. The
bottom of the
lower section
should sit on
the tags as
shown.
Page 30
INSTALLER GUIDE
Figure 36. Fitting the lower section to
the ‘Chic’ fascia.
Figure 35. Fitting the ‘Chic’ hanging trims
Figure 34. Fascia securing