Unit installation

14. FASCIA FITTING
14.1 Fitting the Decadent fascia
! Remove any protective film from the fascia.
! Locate the two lugs at the top of the fascia in the slots
in the convection box hood. Swing the bottom of the fascia
sides back against the convection box and lower the fascia
so that the lugs are fully
seated in the slots in the
convection box hood (See
figure 30).
! Refit the two screws to
secure the bottom of the
fascia sides to the
convection box side
brackets.
! Check that the two
screws in the back of the
fire front casting are in the
inner threaded holes. If they are in the outer
holes, relocate them (See figure 31)
! Fit the fire front casting between the fascia
sides. Where fitted to the casting, locate the two
screw heads at the rear top corners of the casting
through the keyhole slots at the inner sides of
the fascia. If the screw heads do not project
enough or project too far, the screws can be
adjusted.
! Lower the casting so that it rests on the
hearth (See figure 32).
! Fit the "ash pan" cover
below the front casting
locating it as shown in figure
33.
Page 29
INSTALLER GUIDE
Figure 33. Ash pan location
Figure 32. Fire front casting location
Figure 31 Casting screw position.
Figure 30. Fascia fitting
(Fascia may differ from
that shown)