Unit installation

11. CERAMIC PEBBLES INSTALLATION
This section is for models supplied with a ‘Pebble’ fuel effect only.
For ‘Coal fuel effect’ see section 10.
11.1 Ceramic Pebble fuel effect installation for Chic model.
The ceramic fuel effect may cause staining /
discolouration to decorative surfaces. It is therefore
advisable to protect decorative surfaces.
1. Fit the ceramic pebble base into the fire above the
burner. The front of the ceramic pebble base should locate
on the horizontal faces but behind the vertical faces of the
two location brackets positioned at the front of the burner
module (See figure 22).
The pebbles should be positioned so that the arrows
always point towards the back of the firebox. When
located into position the stem of each arrow should be at
90° to the rear of the firebox.
2. Hold pebble ‘A’ upright
with the arrow pointing to
the top. Locate pebble ‘A’ as
shown in figure 23.
Page 25
INSTALLER GUIDE
Figure 23.
Figure 22. Ceramic pebble
base location