Unit installation

10. CERAMIC COALS INSTALLATION
This section is for models supplied with a ‘Coal’ fuel effect only.
For ‘Pebble fuel effect’ see section 11
10.1 Ceramic coal fuel effect installation for the Decadent model.
The ceramic fuel effect may cause staining /
discolouration to decorative surfaces. It is therefore
advisable to protect decorative surfaces.
1. Fit the ceramic coal into the fire above the burner. The
front of the ceramic coal should locate on the horizontal
faces but behind the vertical faces of the two location
brackets positioned at the front of the burner module. See
figure 16.
The coals should be positioned so that the arrows always
point towards the back of the firebox. When located into
position the stem of each arrow should be at 90° to the
rear of the firebox.
2. Hold coal ‘A’ upright with the arrow pointing to the
top. Locate coal ‘A’ as shown
in figure 17.
Page 23
INSTALLER GUIDE
Figure 17.
Figure 16. Ceramic coal
base location