Unit installation

5.3.2 Check flame control motor.
(See figure 8)
! Lift the plastic battery holder out of its
metal support situated at the lower right
corner.
! Fit the four 1.5V batteries and replace the
battery holder.
! Place the fascia in front of the fire and
connect the battery and motor leads. The
motor lead connectors are two different sizes.
They will only fit to the correct motor
terminals.
! Depress the top half of the rocker switch
located at the right side of the appliance case.
This should cause the flame control knob
(The left-hand control knob) to rotate
anticlockwise until it is vertical. Depressing the bottom half of the rocker switch should
then cause the knob to rotate almost 180º clockwise. A clicking sound will be heard
while the flame control knob is rotating.
6. GAS SUPPLY CONNECTION
A nut & olive are provided for an 8mm pipe inlet connection to the inlet ‘T’ connector
at the bottom front of the appliance. This can be rotated to allow a connection from any
direction and includes a valve for isolating the gas supply.
The supply pipe must be rigid material. Flexible pipe must not be used.
Concealed supply pipe connecting from rear of the appliance.
Before the appliance is installed it will be necessary to extend the supply line so that it
will project through the sealed opening at the back of the fire case and run to the inlet
‘T’ connector at the front.
Make sure that the supply line run up to the rear opening is kept away from the area that
will be taken by the appliance case when it is installed.
Note that when fitted the centre of the appliance inlet ‘T’ connector is 25mm above the
floor.
Cut a slit in the seal at the back of the appliance case. The seal must envelop the pipe.
Do not slit the seal unless the supply pipe is to pass through it.
Cap the open end of any supply pipe installed before the wall is drilled to prevent
any debris or dust etc. entering the pipe.
Page 14
INSTALLER GUIDE
Figure 8. Flame control motor check