Unit installation

5.2 Appliance disassembly.
5.2.1 Fascia removal on the Decadent model (See figure 5).
! Remove the two screws securing the bottom of the
fascia to the sides of the convection box.
! Raise the fascia to allow the retaining lugs at the top to
clear the slots in the convection box hood and then lift
clear.
! Place the fascia in a safe place
away from your immediate work area.
5.2.2 Window and ceramic fuel
effect removal (Both models).
! Unscrew and remove the three
spring loaded window fixing screws
and washers from the base of the
window frame (See figure 6). Keep
the screws and washers in a safe
place.
! Gently swing the base of the
window frame forward while lifting
the frame upward. The window
should lift clear of the fire. Put the
window in a safe place away from
your immediate work area.
! Carefully remove the ceramic fuel effect in its packaging. The ceramic fuel effect
base is a single piece. The individual ceramic pieces are packed separately. Put them in
a safe place away from your immediate work area.
5.3 Preliminary checks.
5.3.1 Check ignition spark.
The pilot burner and electrode unit is at the left front
corner of the burner.
! Push in the right hand control knob and turn
anticlockwise through the ignition position marked
and up to the pilot position marked . A
spark should flash across from the pilot electrode to the
pilot burner hood. If there is no spark, check that the
spark gap is as shown in figure 7.
Page 13
INSTALLER GUIDE
Figure 6. Window
removal
Figure 5. Fascia removal
Figure 7. Ignition check